| Author |
Message |
Mitch Miller, AIA ,FCSI, CCS
Senior Member
Username: m2architek
Post Number: 130
Registered: 02-2004
| | Posted on Thursday, March 16, 2017 - 12:38 pm: |    |
Does anyone produce a tapered insulation that is 1/16" per foot?
M2 (Mitch Miller, AIA, FCSI, CCS) |
George A. Everding, FCSI, CCS, CCCA, AIA
Senior Member
Username: geverding
Post Number: 852
Registered: 11-2004
| | Posted on Thursday, March 16, 2017 - 01:41 pm: | |
Firestone. |
Mitch Miller, AIA ,FCSI, CCS
Senior Member
Username: m2architek
Post Number: 131
Registered: 02-2004
| | Posted on Thursday, March 16, 2017 - 01:49 pm: | |
thanks George. Also found out that Hunter makes them.
M2 (Mitch Miller, AIA, FCSI, CCS) |
Ron Beard CCS
Senior Member
Username: rm_beard_ccs
Post Number: 441
Registered: 10-2002
| | Posted on Tuesday, March 28, 2017 - 07:45 pm: | |
Why would anyone want a 1/6" per foot taper?
What is the percentage of probability that it would be constructed perfectly level to achieve a 1/16" per foot gradient?
"Fast is good, but accurate is better."
.............Wyatt Earp |
George A. Everding, FCSI, CCS, CCCA, AIA
Senior Member
Username: geverding
Post Number: 853
Registered: 11-2004
| | Posted on Tuesday, March 28, 2017 - 09:59 pm: | |
Ron, I had the same question, especially remembering that code minimum was 1/4"/ft, unless that has changed. Then I figured it must be a renovation project of an existing roof. Is it, Mitch? |
|
4specs.com Home Page